Enttec DMXUSB PRO

Is not asking for a password. Now I'm trying with the Mk2 and the same problem happens. It's seems the DMX signal is not arriving strong enough on the device, because when i'm changing the channels intensities some colors (is a PAR LED)are blinking.

after one hour:

I installed DL (copied from my notebook) in a MacMini and it worked normally.
Also i did installed again at my notebook and the problem persists.
It's a big mystery. I'm sure is not a hardware problem because i tried with two USB DMX from Enttec and both are working.
First i thought if was an USB output problem from my notebook, but also not otherwise when i run LXConsole the DMX device responded normally.

So i rememberedwhat different i did on my computer after last time i did run a show from it.
I downloaded and opened the Korg Kontrol Editor to setup the buttons of my nano control. May this action did affect the USB outputs...?

Nope.

Notebook... pc are notebook. Mac are macbook, macbook pro...

But previously you said you cannot connect to the usbdmxpro, and now you say that led are blinking.
If they blink it means that the usbdmxpro is well connected and you reach the end of the trial period.

Isn't it the case?

++

Hi !

Which version of :Light do you use ?

Regards,

Jérémie

It;s a macbook. Sorry, language mistake.
Oh no! Trial period end... yes probably.
But i didn't receive any message.
There is a link to extend period or pay for using DL?
At the donation field?
Thanks.

HI Jeremie Is the latest 4.0.0_78beta
Thanks
Regards.

hello Aboll

You could find an extension here :
getdlight.com/

G68F-UZG5-K4BY-9NJW-XD26-NW2R-46XT (trial extension)

The last release it's the 4.0.1

tell us if it's good
see you